| Error Code |
What It Means |
Common Causes |
| E108 |
The system has detected duplicate or conflicting communication addresses. |
|
| E124 / 101 |
The indoor unit is sending signals that are not being received correctly. |
|
| E154 |
The indoor fan is not operating as expected. |
Fan motor malfunction, fan feedback error |
| E162 |
The outdoor unit’s memory (EEPROM) has detected an error. |
EEPROM corruption, power surge affecting outdoor PCB |
| E201 |
The indoor and outdoor units cannot correctly identify or track each other after power-up. |
Incorrect indoor unit quantity setting, communication tracking failure |
| E202 |
Communication failure after indoor units have completed tracking. |
Indoor units not responding, communication line fault |
| E452 |
The system has shut down immediately due to abnormal power conditions. |
Sudden voltage fluctuation, power instability. |
| E458 |
A fan is running at an abnormal speed. |
Fan motor fault, speed feedback error |
| E554 |
The system has detected a possible refrigerant (gas) leak. |
Refrigerant pressure abnormality detected by sensors |
| E462 |
The system has stopped to protect itself from excessive electrical current. |
High current draw, electrical overload condition |
| E465 |
Compressor operation is being limited to prevent damage. |
Overload protection, abnormal compressor load |
| 203 |
Communication error between outdoor main control and inverter control. |
Communication failure between main PCB and inverter PCB |
| 425 |
Power cable is incorrectly connected or detected as miswired. |
Incorrect power wiring or loose power connection |
| 458 / 475 |
Outdoor fan error affecting Fan 1 or Fan 2. |
Outdoor fan motor or feedback fault |
| 461 |
The inverter compressor failed to start correctly. |
Compressor starting failure, inverter control issue |
| 604 |
Repeated communication errors between wired remote control and indoor unit or ventilation system. |
Communication instability between controller and system |
| 653 |
A temperature sensor is reading open circuit or short circuit. |
Sensor failure or wiring issue |
| EA |
Wired remote controller option or communication setting error. |
Incorrect remote controller configuration |